Aggarwal Brothers

Product Brief

AGG BRO ABM1000 is  Self Adhesive Waterproofing Membrane protected by Cross Laminated High - Density HDPE Film. ABM1000 consists of a special mofied Special compound that remains adhesive even at low temperatures. The cross-laminated high- density polyethylene film gives the membrane characteristics of dimensional stability and ensures uniform reaction to elongation stresses in a longitudinal and transversal direction. This membrane has been studied and developed for the specific waterproofing of vertical walls, foundations and basements and all applications where there is required fast techniques that ensure secure results with reasonable costs.

Features : 

Cold Applicaton : Installed without any use of open flame
Chemical Resistance : The Protective HDPE film is resitant to acid, alkalis and other polluntants.
Flexibiltiy & adaptability : This Membrane will adapt easily to irregulary shaped surfaces and will stretch without breaking or cracking.
Self Sealing : The membrane self seals on contact with any substrate maintaining its watertightness.

Applications

Waterproofing in Roofs, Waterproofing of foundations and horizontal and vertical underground structures; Waterproofing in atmospheres not compatible with the use of free fire flames (i.e. factories or warehouses were flammable chemical agents are produced or stored).


SurfacePreparation

The Surface should be clean, dry, smooth and dust-free. If the surface is porous, apply a coat of Solvent Based Primer.

Application 

ABM-1000 should always be applied from the lowest point to enable laps to shed water. All edge and end laps must be overlapped a minimum of 60 mm. Internal and external corners shall be reinforced with an extra layer of membrane 300 mm wide. All end laps and exposed edges should be sealed. On vertical surfaces the installation should start at the lowest point with the joints overlapping by at least 100 mm and formed so that they will shed water. 
 

AGG BRO Self-adhesive carrier less Specially modified Bitumen membrane with spunbond as the top protective layer is designed for indoor waterproofing. Thanks to the special adhesive bitumen compound, the material can be used for indoor works, where the standard torch-on application is forbidden.

Agg Bro waterproofing material is produced by placing a special self-adhesive binder on a spunbond that covers the material on top. The other side of the material is covered with a removable protective film. The absence of a carrier is a key feature of this material that makes it very elastic and flexible.

ADVANTAGE

  - Used for indoor waterproofing with the direct installation of ceramic tiles onto the material without the need of protective sand cement screed (spunbond has to be treated with the contact primer before application of tile adhesive).
-  Can be used on bases, where the standard torch- on application is forbidden (wood, XPS, etc.).
- High speed of application.
-  Safety and cheap application – the membrane is applied without the use of gas and flame.
-   No need for any additional equipment and skills.
-  Cold application method prevents smoke, odors and noise.